During the exterior light check, the brake lamps illuminate but remain on after you release the service brake. Is that satisfactory?
Correct answer: No; they should illuminate on application and turn off on release.
The handbook requires checking both responses: brake lights on with brake application and off with release. A lamp that stays on cannot communicate braking changes correctly.
Source: Colorado CDL Manual (06/15/23), Section 11M.4, Lights Operations Check, physical PDF page 138. Modernized testing model; reviewed September 14, 2026. ↗
You must stop while waiting to make a turn in the road test. How should the front wheels be positioned?
Correct answer: Aimed straight ahead while waiting.
Section 13 specifies straight front wheels while stopped before the turn. Keep the vehicle from rolling and recheck traffic before starting the maneuver.
Source: Colorado CDL Manual (06/15/23), Section 13.1.1, Turns, physical PDF page 130. On-road testing guidance; reviewed September 14, 2026. ↗
A stop is required at an intersection with a marked stop line. What should the road-test stop demonstrate?
Correct answer: A complete controlled stop behind the line, without rolling.
Section 13 evaluates a smooth complete stop at the required position, a safe gap behind vehicles ahead and no forward or backward roll. Vehicle size does not remove the need to respect the stop line.
Source: Colorado CDL Manual (06/15/23), Section 13.1.2, Intersections, physical PDF page 130. On-road testing guidance; reviewed September 14, 2026. ↗
After traffic checks and signaling for an expressway exit, where does the handbook describe smooth deceleration?
Correct answer: In the exit lane, continuing within the ramp's lane markings.
Section 13 describes smooth deceleration in the exit lane and continued controlled slowing on the ramp. Stay within its markings and maintain adequate space around the vehicle.
Source: Colorado CDL Manual (06/15/23), Section 13.1.5, Expressway or Rural/Limited Access Highway, physical PDF page 131. On-road testing guidance; reviewed September 14, 2026. ↗
For the road-test roadside stop, which final location is appropriate?
Correct answer: Parallel to the shoulder and safely clear of the traffic flow.
Check traffic and signal right before a controlled stop. The vehicle should finish parallel and out of traffic without blocking driveways, hydrants, intersections or signs.
Source: Colorado CDL Manual (06/15/23), Section 13.1.6, Stop/Start, physical PDF page 131. On-road testing guidance; reviewed September 14, 2026. ↗
