DMV Practice LabAll tests

Texas CDL Texas Commercial Rules: test 2

Selected knowledge practice, not a complete licensing course or practical training.

Texas Commercial Rules 2

Practice mode
Question 1 of 10
  1. 1. What color must a Texas commercial vehicle’s front clearance lamps and front-side marker lamps show?
  2. 2. What color must clearance lamps and side marker lamps mounted at or near the rear show under Texas law?
  3. 3. Under the ordinary Texas special-lighting mounting rule, at what height should a reflector be installed when the low-structure exception does not apply?
  4. 4. A semitrailer is 32 feet long. Which additional side equipment does the Texas 30-foot rule require?
  5. 5. For an ordinary motor vehicle in the Texas slow-moving definition, what is its maximum design-speed threshold?
  6. 6. May a slow-moving-vehicle emblem be used on a stationary gate as a general warning marker in Texas?
  7. 7. How must a required slow-moving-vehicle emblem be oriented and maintained?
  8. 8. Outside a business or residential district, your truck follows another truck. If conditions permit, what extra purpose must the gap serve?
  9. 9. Traffic approaches in the opposing lane while a bicycle occupies your passing path. What does the Texas commercial safety guidance recommend?
  10. 10. If you must back across a sidewalk into a street, which extra checks does the Texas commercial chapter describe?
Review all 10 questions with answers
  1. What color must a Texas commercial vehicle’s front clearance lamps and front-side marker lamps show?

    Correct answer: Amber

    The same section specifies amber for the covered reflectors and center markers.

    Source: Texas Transportation Code §547.353(a) ↗

  2. What color must clearance lamps and side marker lamps mounted at or near the rear show under Texas law?

    Correct answer: Red

    Do not confuse rear marker color with front or center marker color.

    Source: Texas Transportation Code §547.353(b) ↗

  3. Under the ordinary Texas special-lighting mounting rule, at what height should a reflector be installed when the low-structure exception does not apply?

    Correct answer: 24 to 60 inches

    If the permanent structure is below 24 inches, the statute instead specifies as high as practicable on that structure.

    Source: Texas Transportation Code §547.354(a) ↗

  4. A semitrailer is 32 feet long. Which additional side equipment does the Texas 30-foot rule require?

    Correct answer: A centrally mounted marker lamp and reflector on each side

    The rule specifies central markers and reflectors on both sides; the applicable hazard-lamp requirement also remains.

    Source: Texas Transportation Code §547.352(3) ↗

  5. For an ordinary motor vehicle in the Texas slow-moving definition, what is its maximum design-speed threshold?

    Correct answer: 25 mph or less

    This refers to design capability, not simply a faster vehicle being driven slowly. Special vehicle provisions can also apply.

    Source: Texas Transportation Code §547.001(7) ↗

  6. May a slow-moving-vehicle emblem be used on a stationary gate as a general warning marker in Texas?

    Correct answer: No

    Texas restricts the emblem to its intended slow-moving-vehicle use, rather than stationary objects.

    Source: Texas Transportation Code §547.005(a) ↗

  7. How must a required slow-moving-vehicle emblem be oriented and maintained?

    Correct answer: Base down at the rear, clean and reflective

    Mount it so its visibility is not impaired. A dirty or obstructed emblem does not provide the intended warning.

    Source: Texas Transportation Code §547.703(a) ↗

  8. Outside a business or residential district, your truck follows another truck. If conditions permit, what extra purpose must the gap serve?

    Correct answer: Let a passing vehicle safely enter the space

    This truck-following provision complements the general duty to keep enough clear distance to stop safely.

    Source: Texas Transportation Code §545.062(b) ↗

  9. Traffic approaches in the opposing lane while a bicycle occupies your passing path. What does the Texas commercial safety guidance recommend?

    Correct answer: Slow and follow until there is room to change lanes and pass safely

    Large vehicles can disturb a two-wheeler with airflow. Wait for a safe lane-changing pass rather than crowding the rider.

    Source: Texas DL-7C March2026,14.6(3),PDF185 ↗

  10. If you must back across a sidewalk into a street, which extra checks does the Texas commercial chapter describe?

    Correct answer: Stop at the sidewalk for people, then check traffic again at the curb

    Avoid backing into the street when a safer arrangement is possible. When unavoidable, separately check the pedestrian area and roadway.

    Source: Texas DL-7C March2026,14.6(2)(h),PDF185 ↗

Report a problem with this question

Question reference: tx-cdl-rules-021

Opens a draft in your email app. Review and send it there; nothing is sent automatically.

Draft a correction email

Contact details & help

Study tools & test information