Which tractor-trailer condition particularly increases the chance of getting hung up on a raised railroad crossing?
Correct answer: Low clearance under the trailer or its landing gear.
A raised crossing can catch low-slung equipment or landing gear. Check the route and clearance before entering; once stuck, get clear of the tracks and seek emergency help.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Low-clearance rail crossing; physical PDF page 80 (printed 6-2); reviewed September 14, 2026. ↗
You are driving a tractor without its semitrailer. What should you remember about braking?
Correct answer: Low weight on the rear drive axles can make smooth stopping more difficult.
A bobtail tractor can have poor drive-axle traction and be difficult to stop smoothly. Allow adequate space; actual stopping performance depends on the vehicle, brakes, load and road.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Bobtail braking; physical PDF page 79 (printed 6-1); reviewed September 14, 2026. ↗
The trailer wheels have locked during braking and the trailer begins to swing. What action addresses the cause of this trailer skid?
Correct answer: Release the braking that caused the lockup so the trailer wheels can regain traction.
A locked trailer wheel cannot provide normal directional grip. More trailer braking worsens this skid. This describes an actual wheel-lock trailer skid, not a general instruction to pump functioning ABS.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Trailer-wheel skid; physical PDF page 81 (printed 6-3); reviewed September 14, 2026. ↗
A curved backing maneuver with a semitrailer cannot be avoided. Which side does the handbook favor when a safe setup permits it?
Correct answer: Back toward the driver’s side for better visibility.
Driver-side backing generally gives a better view of the trailer and path. Straight backing is preferable when possible; inspect the area and stop to look again whenever uncertain.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Backing visibility; physical PDF page 81 (printed 6-3); reviewed September 14, 2026. ↗
During ordinary driving, which control should normally apply the tractor and trailer service brakes together?
Correct answer: The foot brake pedal.
The foot pedal controls service braking throughout the combination. The trailer hand valve is for checking trailer brakes, not routine driving or straightening a skid.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Trailer hand valve in traffic; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
Why is the trailer hand valve unsuitable as a parking brake?
Correct answer: Air can leak away and release the brakes it applied.
A hand-valve application depends on air pressure and is not a secure parking method. Use the correct parking system and suitable chocks, especially for trailers without spring brakes.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Hand valve is not parking; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
A trailer air hose tears apart. What is the purpose of the tractor protection valve?
Correct answer: Protect the tractor’s braking-air supply from escaping through the trailer system.
The protection system limits the trailer failure’s effect on tractor air. It cannot repair the damaged connection or authorize continued operation of an unsafe combination.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Tractor air protection; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
On a newer tractor with the standard red eight-sided trailer-air control, what does pushing it in do?
Correct answer: Supplies air to the trailer system.
The red control is pushed in to supply trailer air and pulled out to shut off supply and activate trailer emergency braking. Know any different controls on the actual vehicle.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Red trailer-supply control; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
What does the air pressure in the trailer service line communicate?
Correct answer: The amount of braking requested by the pedal or hand control.
The service or control line carries the braking signal to relay valves. It is not the line whose principal job is charging the trailer reservoirs.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Service-line signal; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
Which pair of functions belongs to the trailer emergency or supply air line?
Correct answer: Charge the trailer tanks and control emergency braking when supply pressure is lost.
The supply line fills trailer reservoirs. Loss of its pressure also activates the trailer emergency-brake system; it has a different job from the service signal line.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Supply-line functions; physical PDF page 82 (printed 6-4); reviewed September 14, 2026. ↗
How do relay valves help the trailer service brakes respond promptly?
Correct answer: They deliver air from nearby trailer reservoirs in response to the service-line signal.
The control signal tells relay valves how much reservoir air to send to the trailer brakes. Supplying that air locally speeds the response.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Trailer relay valves; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
When standard red and blue air-line markings are used, which connection is correct?
Correct answer: Red to emergency/supply and blue to service.
The usual color code separates the red supply line from the blue service line. Verify markings and the vehicle’s connections rather than assuming every hose is correctly identified.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Identifying air connections; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
Before joining the tractor and trailer glad hands, what should be checked?
Correct answer: That the rubber seals and mating surfaces are clean and sound.
Damaged or dirty seals can cause air leaks. Properly matched, clean couplers form the sealed connection needed for brake operation.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Glad-hand seals; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
After supplying trailer air, the trailer spring brakes will not release. What connection error should you investigate?
Correct answer: The service and supply air lines may be crossed.
Crossed lines can send supply air into the service circuit instead of filling the trailer reservoirs. Diagnose the fault before moving; do not force the vehicle against the brakes.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Crossed lines and spring brakes; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
Why is being able to pull an older trailer without spring brakes not proof that its air lines are connected correctly?
Correct answer: It may roll even though crossed lines have left it without working trailer brakes.
An older trailer with depleted stored air may roll freely. Perform the required trailer-brake checks rather than using movement as evidence of a safe connection.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Older trailer moves without braking; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
After disconnecting a trailer, why should unused air hoses be attached to suitable dummy couplers?
Correct answer: To keep water and dirt out of the air connections.
Dummy couplers protect the disconnected lines from contamination. Secure the hoses too, so they cannot drag or strike moving parts.
Source: Ohio Commercial Driver License Manual, HSY 7605 7/26, Section 6 (July 2017); Unused glad hands; physical PDF page 83 (printed 6-5); reviewed September 14, 2026. ↗
